Matrox Imaging Library (MIL) now includes native support for USB3 Vision cameras.

10 april 2014
DVC component news, OEM High Speed Recording, OEM On The Spot news, OEM Seal Inspector News

Matrox Imaging  announced immediate availability of complete native support for the USB3 Vision™ camera interface standard in Matrox Imaging Library (MIL). This lets MIL users take advantage of USB3 Vision cameras on Windows® 7 and Windows 8 imaging systems and increases the selection of camera interface standards that can be employed practically interchangeably.

The USB3 Vision standard, built on the GenICam™ generic programming interface, provides powerful features such as bandwidth higher than 350 MB/s, an easy-to-use plug and play interface, and support for power and data up to five meters over a passive cable or even greater distances over an active cable. Matrox support for USB3 Vision meets AIA certification requirements and has been validated throughout its development with cameras from Basler, Baumer, MATRIX VISION, Point Grey, Sentech, Toshiba Teli and XIMEA.

Our low-level implementation of the USB3 Vision standard in MIL maximizes the video transmission rate possible over SuperSpeed USB while imposing little CPU overhead. For example, we capture 2048x2048 8-bit monochrome images from a Point Grey GRASSHOPPER3 camera at an impressive 90 fps,” said Stéphane Maurice, director of software development at Matrox Imaging and vice-chair of the GenICam committee. “Our customers can now use MIL to seamlessly integrate USB3 Vision cameras into their high-performance imaging systems for factory automation, process control, electronics and pharmaceutical packaging, semiconductor inspection, robotics, radiology, microscopy, and video surveillance.

Availability

Matrox support for the USB3 Vision camera interface standard is an update to MIL 10 and is now available to MIL registered users with valid maintenance subscriptions through the software’s self-update service.

DVC Machinevision bv

Hoofdkantoor
Minervum 7069
4817 ZK Breda
Nederland

T. +31 (0)76 544 05 88
F. +31 (0)76 541 78 93
E. sales@machinevision.nl

KvK Breda # 14057165
BTW nr NL.80.66.47.772.B01
Bank IBAN NL50RABO0156555603
BIC code RABONL2U

DVC machinevision Duitsland

Sales & support office
Tel. +49 381 8388 0059
info@dvcmachinevision.de

www.dvcmachinevision.de

Vragen? Wij helpen u graag!